ZEQUO 5410DL(PN88162C) Release Note

April 5, 2024: Version 1.0.0.18
- Resolved Issues: 
1) When the unique frame (CDP, PVST+, etc.) sent by another company's device 
   is received during redundancy configuration or port blocking with loop detection,  
   it is forwarded to another port then loop is occurred.


December 2, 2022: Version 1.0.0.17
- Resolved Issues: 
1) It may not be released memory when the device operates a long time continuously.
2) It may unstable to routing communicate when RIP operates over 497 day.
3) When the device receives other company original frame (CDP and PVST+) at link aggregation member port,
   it forwards to other ports which belong same link aggregation group.


July 1, 2022: Version 1.0.0.16
- Resolved Issues: 
1) When configure stacking and Link aggregation with fiber port and power off the stacking master device, 
   it is not able to communicate on stacking backup master.
2) When configure stacking and reboot, the stacking device may not configure stacking again.
3) When the device receive a lot of RIP route information and receive UDP or TCP packets, the device may be unstable.


March 11, 2022: Version 1.0.0.15
- Resolved Issues: 
1) Modified DNS packets forwarding process of DNS relay.


January 1, 2022: Version 1.0.0.14
- A New Function:
1)Link flap prevention

- Resolved Issues: 
1) If a link up / down occurs instantly at the SFP port of the device, the device may stop responding.
2) If you connect to a device that supports PVST + by link aggregation, you may not be able to communicate normally.
3) After restarting, the loop detection function setting for ports 5 to 16 is switched from enabled to disabled.
4) Corrected the execution hierarchy of the "crypto certificate NUMBER request" command to privileged mode.
5) When the RRP management port is plugged in or unplugged, the RRP status becomes Fail and does not recover.


May 14, 2020: Version 1.0.0.11
- Resolved Issues: 
1)When you configure IPv6 address and the device receive the IPv6 packets, bad connections occur.


November 20, 2020: Version 1.0.0.10
- Resolved Issues: 
1) The ACL which specify TCP/UDP port range are configured only 4.  
2) When you configure “logging server” and “logging origin-id ip” 
   also the device detects loop, an error message may be output and bad connections occur.
3) When device transfer other company's tagged RPVST frame, it adds unnecessary vlan tag.


July 20, 2020: Version 1.0.0.9
First release.