Switch-M5eGLPWR+(PN28058) Release Note

November 22, 2019: Version 2.0.0.02
- Specification Changes:
1.Add time information to Syslog send by PPS Notification.

- Resolved Issues:
1.If the PPS function change to enable, operation may become unstable .
2.PPS version upgrade may fail.
3.Corrected the display of the PPS connection setting screen of the WEB setting interface.


May 13, 2019: Version 2.0.0.01
- Resolved Issues:
1.When link up/down is repeated during PoE power supply with LLDP disabled, the following message is displayed and the system does not operate normally.
 E"Fatal Error: System_Memory Pool Exhausted. ERROR_CODE is -32"

January 9, 2019: Version 2.0.0.00
- Add New Function:
1.PPSP(Power to Progress SDN@Protocol)
2.Added blocking mode at Loop detection function.
  Changed default mode "shutdown" to "blocking".

- Resolved Issues:
1.MDI / MDI-X setting of the link aggregation member port returns to the factory setting after rebooting.
2.MDI / MDI-X setting of the link aggregation member port can not be changed after setting link aggregation.
3.Different speed and full-duplex/half-duplex settings can be done with the link aggregation member port.
4.The SFP port is not linked up when turning on or rebooting rarely.
5.System up time is reset on 49 days.
6.Executing the "show lldp neighbors detail" command may cause the console, TELNET, SSH to stop responding.


March 27, 2018: Version 1.0.0.27
- Resolved Issues:
1.Own device's CPU handled Unicast ARP frame.


December 11, 2017: Version 1.0.0.24
- Resolved Issues:
1.If the session is disconnected during SSH connection, reconnection can not be executed.

- Known Issues:
1.When connecting to a specific PoE powered device connected to an AC power source, the port PoE LED may blink.


August 29, 2016: Version 1.0.0.19
- Resolved Issues:
1. RRP Management packets are sent as 60 bytes.
2. DDM threshold is not set the correct value when set Auto.
3. Time can not be displayed in web interface.


January 28, 2016: Version 1.0.0.14
- Resolved Issues:
1. Some PIM control packets are dropped when IGMP Snooping is enabled.
2. Sometimes several port configuration commands are not outputted when executing running-config, saving configurations, uploading configurations via TFTP.


October 30, 2015: Version 1.0.0.11
- Specification Changes:
1. Change definition of ifName for SNMP.
  ex) Port1: eth0 --> gi0/1

- Function Addition:
1. Add Japanese translation in WEB configuration.

- Resolved Issues:
1. Latest statistics information cannot be got over SNMP.
2. Loop detection does not work while storm control is enabled.


February 23, 2015: Version 1.0.0.02
First release.